Matching development cleaner

I. Product composition:

1 barrel detergent A component stock solution

1 barrel detergent B component stock solution

1 barrel 4 neutralizer stock solution

II. Preparation

Preparation of 1 liter detergent working fluid needs:

Preparation of 1 liter neutralizer working fluid needs:

875 ml warm water (18-32ºC)+125 ml neutralizing solution =1 l

III. Points for attention

Be sure to wear appropriate protective clothing and goggles when operating the potion!

This potion can not be used in bleaching and fixing tanks.

Never mix cleaning agents and neutralizers directly.

IV. Preparation

Empty development cylinder development working fluid, remove filter element.

2. rinse the tank frame, bridge and working cylinder with about 38ºC of warm water, then fill the cylinder with warm water, open the circulation system and remove the developer residue with clear water bubble cylinder.

After soaking the 3. for a period of time, empty the water in the working cylinder.

4. carefully pour the cleaning agent into the working cylinder according to the required volume, close the supplementary system (prevent the development from adding the cleaning agent into the cylinder), and open the circulation system for soaking and cleaning.

Note: the setting temperature in the working cylinder is generally about 38ºC, and the general working temperature of the cleaning agent is 18ºC -35ºC, so circulating heating in the working cylinder may produce fog. Can reduce the working cylinder setting temperature to avoid this problem, but after cleaning do not forget to set back to the original temperature.

5. in theory, the cleaning agent can be cleaned and soaked in the cylinder for 5-30 minutes, then empty the cleaning agent, pour into warm water and then soak and clean.

Note: cycle steps 2 to 5 according to cylinder cleanliness.

6. before pouring neutralizer, be sure to clean and soak the process. Then pour the neutralizer and cycle for 5-30 minutes.

7. empty neutralizer, pour in clean water again to clean the working cylinder, completely wash off the liquid and residue in the cylinder.

8. replace the new filter and pour into the developer to ensure that the temperature is set at the correct value.

Note:

1. tank rack and bridge can be taken out separately and washed in the sink. Rinse with clear water —— cleaning agent —— neutralizer and clear water. It is recommended to use a spray kettle, but never use a spray kettle (spray will spread in the air, harmful to the human body).

2. this cleaning agent can be saved after cleaning and can be reused many times in two weeks. But if the vitality weakens when used again, add 20 ml of A and 20 ml of B concentrate per liter of. If the preserved working fluid is found to have lost its purple color, it is useless.

Previous:Nothing

ShenZehn Varmia Technology Co.,Ltd

Address: Room 901, Building A, Exhibition Center, E-Commerce Building, Taojindi, Tenglong Road, Longhua District, Shenzhen

Tel: 0755-27659820

Fax: 0755-27659830

Mobile: 13302956659 (Mr.liu)

Email: hmy-tech@163.com

Website: www.szhmy.net

ShenZehn Varmia Technology Co.,Ltd(Pingshan Branch)

Address: Building A, Dawan Culture Plaza, No. 4128 Dongcheng Ring Road, Mawei Street, Pingshan District, Shenzhen

Tel: 0755-27659866

Fax: 0755-27659830

Mobile: 13823780855 (Mr.Wang)

Email: yxyang@hmy varmia.com